T238 DTU V3 BASIC(V1.9) For V3 Gearbox

Describe:
T238 digital trigger unit BASIC is a programmable MOSFET designed for beginners who only need simple functions like stable semi-auto and preventing battery over discharge. The system uses infrared sensors to detect gear rotation, it has many functions, such as  binary trigger, paint ball shooting mode, auto-loading function for gel ball magazine, over heat protection and so on. Besides, it also has the functions of  gearbox block-up protection. It can effectively improve the stability, shooting speed and response speed of gearbox. The module uses a maximum of 16.8V batteries. Soldering and wiring are required.

Functions:

1. Binary trigger. when the trigger is pressed and released, the gearbox will fire once each.

2. Paint ball mode. In this mode, if the trigger switch is triggered at a slower frequency, the system is in single shot mode. If the trigger switch is triggered at a faster frequency, the system is in Binary-trigger mode

3. Block-up protection. When gearbox Block-up occurs, the system stops working and emits an elongated ‘beep’ sound. Please check the wave box immediately by power off.

4. Auto-loading function is designed for gel ball blaster magazines with motor inside, when changing the magazine, the magazine motor will run automatically for 1 second.

5. Short circuit protection. When a short circuit is detected in the motor/magazine circuit, the system will cut off the power to the motor/magazine and prompt through LED flashing. Please disconnect the battery in a timely manner and troubleshoot the problem.

6. Low battery protection. The system will automatically detect the number of battery cells and provide low-voltage protection, with a default protection voltage of 3.2V/cell.

7. When the MOSFET is overheated, after the trigger is pulled, the motor will give a beep prompt until it is automatically restarted after cooling.

Main parameters:

• Size: 100*23*5mm
• Operating voltage: 6-16.8V
• Short circuit protection
• Active brake tech
• Uses optical sensor for gear detection
• Binary trigger and paint ball shooting mode
• MOSFET overheat protection
• Maximum start current is 300A, maximum brake current is 100A, maximum magazine drive current 30A
• Compatible with V3 standard gearbox

Package Content:

• Digital Trigger Unit V3 BASIC    X1
• Manual    X1
• Badge    X1
• Small bag accessories    X1

Shooting Modes:

Binary-trigger mode: In this mode, when the trigger is pressed and released, the gearbox will fire once each

Paint Ball Mode: In this mode, if the trigger switch is triggered at a slower frequency, the system is in single shot mode. If the trigger switch is triggered at a faster frequency, the system is in Binary-trigger mode

Note:

This product requires soldering and wiring. It is recommended that installation is undertaken by an experienced technician.